Celestron NexStar 8SE Computerized Telescope Quick Setup Guide for NexStar 6 S
Celestron NexStar 8SE Computerized Telescope Manual
View all Celestron NexStar 8SE Computerized Telescope manuals
Add to My Manuals
Save this manual to your list of manuals |
Celestron NexStar 8SE Computerized Telescope manual content summary:
- Celestron NexStar 8SE Computerized Telescope | Quick Setup Guide for NexStar 6 S - Page 1
Item # 11068 1 Item # 11069 2 Quick Set-up Guide 3 Your NexStar 6SE or 8SE includes:fork arm with optical tube; tripod; accessory tray; bubble level; computerized hand control; one 25mm eyepiece;StarPointer finderscope; Star diagonal; owner's manual, The Sky® CD,NexRemote Telescope Control CD,RS - Celestron NexStar 8SE Computerized Telescope | Quick Setup Guide for NexStar 6 S - Page 2
up Guide [cont shown above. Tighten silver screw (inset) to secure. To power up telescope, you will first need to insert batteries. Remove battery cover on fork above. Focus Knob In order to get the best view through the telescope, slowly turn the focus knob until the objects are in sharp focus. - Celestron NexStar 8SE Computerized Telescope | Quick Setup Guide for NexStar 6 S - Page 3
your NexStar 6SE or 8SE, you must setup your computerized hand control and go through the SkyAlign alignment procedure. In order for the NexStar to accurately point to the objects in the sky, it must first be aligned with known positions (stars) in the sky. With this information, the telescope can - Celestron NexStar 8SE Computerized Telescope | Quick Setup Guide for NexStar 6 S - Page 4
Hand Control Guide [cont] 13 . 21 INFO Repeat the process for the third alignment star. When the telescope has been aligned to the final star, the display will read "Match your user's manual. If you have questions or problems with set-up, please contact Celestron Technical Support: 310.803.5955
Extend tripod legs 6 to 8 inches by
loosening the tripod leg locking knob
and pulling the leg to desired length and
re-tightening knob.
Assemble tripod by spreading the legs
out until fully extended.
Quick Set-up Guide
1
2
3
To attach accessory tray, remove threaded
nut and washer from accessory tray rod.
4
7
Once tripod is level, put away the bubble
level. Grab scope by the fork arm and
line up holes on bottom of telescope
with the screws on the tripod mounting
platform.
Slide accessory tray onto rod.Replace
threaded nut. Tighten to secure.
5
Tripod legs should be the same
length to
provide a level platform for the telescope.A
bubble level is included to assist in leveling.
6
Tighten three screws under tripod
mounting platform to secure the
fork arm to the tripod.
8
Hand control comes mounted in the fork
arm. Hand control should fit snugly in
fork arm as shown above.
9
Your NexStar 6SE or 8SE includes: fork arm
with optical tube; tripod; accessory tray;
bubble level; computerized hand control;
one 25mm eyepiece; StarPointer
finderscope; Star diagonal; owner’s manual,
The Sky® CD, NexRemote Telescope Control
CD, RS-232 cable.
Item #
11069
Item #
11068
NexStar 6SE, 8SE