Celestron PowerSeeker 80EQ Telescope PowerSeeker 80 Quick Setup Guide
Celestron PowerSeeker 80EQ Telescope Manual
 |
View all Celestron PowerSeeker 80EQ Telescope manuals
Add to My Manuals
Save this manual to your list of manuals |
Celestron PowerSeeker 80EQ Telescope manual content summary:
- Celestron PowerSeeker 80EQ Telescope | PowerSeeker 80 Quick Setup Guide - Page 1
21048 1 Item #31132 Questions or Problems with Set-up? CONTACT: Celestron Technical Support: 310.803.5955 Quick Set-up Guide 2 3 Your PowerSeeker 80 includes: optical tube w/ tube rings & lens shade attached; tripod with center support a level platform for the telescope. 7 Place the accessory - Celestron PowerSeeker 80EQ Telescope | PowerSeeker 80 Quick Setup Guide - Page 2
Guide [cont] 10 11 be extending towards the focuser end of the telescope tube. 18 Reattach both wingnuts and tighten to the threaded posts at the focuser end of the telescope tube. 22 For additional magnification, you can use the telescope. To observe, look through the eyepiece as
-
1 -
2
 |
 |
Use the three tightening screws located at the
bottom of each leg to secure the extended legs
in place.
To set up the tripod, spread the legs outward
until they are fully extended. Extend the center
portion of each of the three tripod legs down 6-
8".
Quick Set-up Guide
1
2
3
All three legs should be the same length to
provide a level platform for the telescope.
4
7
Locate the equatorial mount and place the
base of the mount through the hole in the
center of the tripod mounting platform.
5
Properly assembled, the accessory tray should
appear as pictured above.
6
From underneath the tripod mounting platform,
thread the mounting bolt with washer into the
threaded hole on the bottom of the equatorial
mount.
8
Thread the latitude adjustment screw into the
equatorial mount until it is touching the inside
of the mount.
9
PowerSeeker 80
Your PowerSeeker 80 includes:optical tube w/ tube
rings & lens shade attached;tripod with center
support bracket; equatorial mount; two eyepieces; a
3x barlow lens, finderscope; 5 lb.counterweight;
counterweight bar; star diagonal; two slow motion
cables;eyepiece accessory tray;The Sky™ CD
software;documentation including owner’s manual.
Item# 21048
Place the accessory tray on top of the tripod's
center leg brace.Thread the tray into the
threaded hole in the center of the leg brace.
Questions or Problems with Set-up?
CONTACT:
Celestron Technical Support: 310
.
803
.
5955