Celestron PowerSeeker 80EQ Telescope PowerSeeker 80 Quick Setup Guide - Page 1
Celestron PowerSeeker 80EQ Telescope Manual
View all Celestron PowerSeeker 80EQ Telescope manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 1 highlights
PowerSeeker 80 Item# 21048 1 Item #31132 Questions or Problems with Set-up? CONTACT: Celestron Technical Support: 310.803.5955 Quick Set-up Guide 2 3 Your PowerSeeker 80 includes: optical tube w/ tube rings & lens shade attached; tripod with center support bracket; equatorial mount; two eyepieces; a 3x barlow lens, finderscope; 5 lb. counterweight; counterweight bar; star diagonal; two slow motion cables; eyepiece accessory tray;The Sky™ CD software; documentation including owner's manual. To set up the tripod, spread the legs outward until they are fully extended. Extend the center portion of each of the three tripod legs down 68". Use the three tightening screws located at the bottom of each leg to secure the extended legs in place. 4 5 6 All three legs should be the same length to provide a level platform for the telescope. 7 Place the accessory tray on top of the tripod's center leg brace. Thread the tray into the threaded hole in the center of the leg brace. 8 Properly assembled, the accessory tray should appear as pictured above. 9 Locate the equatorial mount and place the base of the mount through the hole in the center of the tripod mounting platform. From underneath the tripod mounting platform, thread the mounting bolt with washer into the threaded hole on the bottom of the equatorial mount. Thread the latitude adjustment screw into the equatorial mount until it is touching the inside of the mount.