Chamberlain 935CB 935CB - Page 2
OPERATION, Door Control Push Bar, Light Feature, Automatic Light Feature, Automatic Light Override - motion detecting control panel
View all Chamberlain 935CB manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
OPERATION Door Control Push Bar: Press to open or close the door. Press again to reverse the door during the closing cycle, or to stop the door while it is opening. Light Feature: Press the Light button to turn the opener light on or off. When the door is opened or closed, the light will remain on for 4-1/2 minutes. Press the Light button to turn it off sooner. The Light button will not control the opener light when the door is in motion. When using the opener lights as working lights, we recommend that you first disable the motion sensor. See Automatic Light Override Feature, below. When used with openers manufactured after May 15, 1999, (check the date on the opener panel) the 4-1/2 minute interval can be changed to 1-1/2, 2-1/2, or 3-1/2 minutes as follows: Press and hold the Lock button until the light blinks (about 10 seconds). A single blink indicates that the timer is reset to 1-1/2 minutes. Repeat the procedure and the light will blink twice, resetting the timer to 2-1/2 minutes. Repeat again for a 3-1/2 minute interval, etc., up to a maximum of four blinks and 4-1/2 minutes. Automatic Light Feature: The opener light will turn on automatically when a person enters the garage. When a person walks in front of the door control, the opener light will come on for five minutes, then shut off. This feature works by detecting body heat. It is more sensitive in front of the door control than at its sides, and works better as a person moves closer. It may not work in temperatures around 100°F (38°C). To disable this feature, slide the Detector Switch on the right side of the door control down (off). Special note for older garage door openers: If this door control is installed on an opener manufactured from January 1, 1995 to May 15, 1999, the following difference may apply: If the light is on when the opener is actuated, the light may go off for a moment, then turn on again as the detector senses you. Automatic Light Override Feature: We recommend that you disable the motion sensor when using the opener lights as working lights. Otherwise, they will turn off automatically if you are working beyond the sensor's range. Slide the Detector Switch on the right side of the door control down (off), then press the light button to control the lights. Lock Feature: Designed to prevent operation of the door from handheld remote controls. However, the door will open and close from the Door Control, the Outside Keylock and Keyless Entry accessories. To activate: Press and hold the Lock button for 2 seconds. The push bar light will flash as long as the lock feature is on. To turn off: Press and hold the Lock button again for 2 seconds. The push bar light will stop flashing. Normal operation will resume. The Lock feature will also turn off whenever the "Learn" button on the motor unit panel is activated. NOTICE: To comply with FCC and or Industry Canada (IC) rules, adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. 114A2398C © 2007, The Chamberlain Group, Inc. All Rights Reserved