Chicco 05064698800070 User Guide - Page 25

1. Insert the arms into the two shoulder straps openings, one at a time (diag. 1). 2. Adjust the length of the shoulder straps, holding the main adjustment straps. Pull the straps, ensuring they adhere correctly to the shoulders (diag. 2). This operation adjusts the upper rear part of the backrest. 3. Hold both lower buckles with the right hand, and pull the secondary adjustment straps with the other hand (diag. 3), ensuring that the backrest adheres correctly to the bust. Repeat the same operation on the other side. This operation adjusts the lower rear part of the backrest. 4. To ensure maximum comfort while carrying the child, the Ergo System backrest must be placed in a central position, slightly below the shoulder blades (diag. 4): it should adhere correctly to the back and lumbar region of the adult to ensure maximum comfort. GROWTH ADJUSTMENT SYSTEM WARNING: This operation must be carried out before placing the child in the baby carrier. The baby carrier has a special growth adjustment system that allows you to adjust the baby carrier to suit the child's development. 5. Open the two zips, as shown in diag. 5. 6. Hold the height adjustment buckle and pull the strap, until the baby carrier is adjusted to the desired size (diag. 6). 7. Close the panel again at the end of the operation (diag. 7). Information for parents: Some sizes/heights are indicated near the height adjustment buckle of the baby carrier, in order to make the adjustment operations easier. WARNING: Before placing the child in the baby carrier, ensure that the adjustment buckle is fastened correctly into position. HOW TO FIT THE BABY CARRIER TO THE SHOULDER STRAPS 8. To fit the baby carrier to the shoulder straps, it is necessary to hold the lower buckles of the shoulder straps and fasten them to the corresponding lower open/close buckles of the baby carrier (diag. 8). WARNING: Exercise pressure until a "clack" is heard, indicating that the buckle is fastened correctly into position. 9. Adjust the length of the shoulder straps, one at a time, adjusting the secondary adjustment straps, until the baby carrier is closely positioned against the upper part of the adult's thorax (diag. 9). This operation is necessary to ensure maximum comfort for the adult and the child and to distribute the weight in the best way, so ensuring maximum safety for the child. ADJUSTMENT SYSTEM FOR THE PARENT'S BODY WARNING: This operation must be carried out before placing the child into the baby carrier. The baby carrier has an adjustment system that ensures maximum comfort and the best adjustment to any type of body size. 10.Hold the two ends of the upper open/clo- se buckle with the fingertips and exercise a slight pressure on the sides to unfasten the buckle (diag. 10). 11. Raise the tab to release it from its position of use (diag. 11). 12. Slide the buckle set into the appropriate guide, until the desired height is reached (diag. 12). 13.Lower the buckle, and exercise a slight pressure on the side of the tabs to fasten the buckle again in its safety position (diag. 13). Both shoulder straps must be adjusted exactly at the same height. 14.To carry the child in a correct and safe position, the adjustment buckle must be positioned as shown in diagram 14. WARNING: Always check that the buckle is fastened correctly before carrying out any other operations. It will be impossible to fit the baby carrier to the shoulder straps if this adjustment operation has not been carried out correctly and the tabs are not fitted correctly into position. HOW TO PLACE BABY INSIDE THE BABY CARRIER It is recommended that you place the child in the baby carrier while sitting. 25