Cisco 2501 Getting Started Guide - Page 30

Note Press the hyphen key if you need to return to the previous command line. Table 3 Startup Wizard Information Wizard Setting System Name Administrative user name Administrative password Action Enter the system name, which is the name you want to assign to the controller. You can enter up to 31 ASCII characters. Enter the administrative user name to be assigned to this controller. You can enter up to 24 ASCII characters for each. The default administrative username is admin. Enter the administrative password to be assigned to this controller. You can enter from 3 to 24 ASCII characters for each. Management Interface IP Address Management Interface Netmask Management Interface Default Router Management Interface VLAN Identifier Management Interface Port Num [1 to 4] Note There is no default administrative password, you must enter a password. Enter the IP address of the management interface. The management interface is the default interface for in-band management of the controller and connectivity to enterprise services such as AAA servers. You can access the controller GUI interface using the management interface IP address. Enter the IP address of the management interface netmask. Enter the IP address of the default router. Enter the VLAN identifier of the management interface (a valid VLAN identifier or 0 for an untagged VLAN). The VLAN identifier should be set to match the switch interface configuration. Enter the port number of the access point manager interface. Ports values are 1 to 4. 30