Cisco 2950 Software Configuration Guide - Page 253
Configuring Media Types for Gigabit Ethernet Interfaces on LRE Switches, Configuring IEEE 802.3z - qos
UPC - 746320454504
View all Cisco 2950 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 253 highlights
Chapter 11 Configuring Interface Characteristics Configuring Ethernet Interfaces Step 6 Step 7 Command show running-config copy running-config startup-config Purpose Display the LRE interface speed and duplex mode configuration. (Optional) Save your entries in the configuration file. Use the no local speed and no local duplex interface configuration commands to return the interface to the default speed and duplex settings. To return all interface settings to the defaults, use the default interface interface-id interface configuration command. Configuring Media Types for Gigabit Ethernet Interfaces on LRE Switches On the LRE switches, use the media-type interface configuration command to configure the media type for Gigabit Ethernet interfaces. You can enable or disable fiber-optic or copper (10/100/1000) connections. You can also manually set the port to select an SFP connector or an RJ45 connector. Use the no form of this command to return to the default setting of SFP-preferred. To configure media types, use the media-type {auto-select | rj45 | sfp} interface configuration command. For more information, refer to the command reference for this release. Configuring IEEE 802.3z Flow Control on Gigabit Ethernet Ports Flow control is supported only on the 10/100/1000, 1000BASE-SX, GBIC-module, and SFP-module ports. Flow control enables connected Gigabit Ethernet ports to control traffic rates during congestion by allowing congested nodes to pause link operation at the other end. If one port experiences congestion and cannot receive any more traffic, it notifies the other port to stop sending until the condition clears. When the local device detects any congestion at its end, it can notify the link partner or the remote device of the congestion by sending a pause frame. Upon receipt of a pause frame, the remote device stops sending any data packets, which prevents any loss of data packets during the congestion period. Note We strongly recommend that you do not configure IEEE 802.3z flow control when quality of service (QoS) is configured on the switch. Before configuring flow control on an interface, make sure to return to the default QoS settings listed in the "Default Standard QoS Configuration" section on page 30-18. Flow control can be implemented in two forms, symmetric and asymmetric. The symmetric implementation is suitable for point-to-point links, and asymmetric is suitable for hub-to-end node connections, where it is desirable for the hub to pause the end system, but not vice-versa. You use the flowcontrol interface configuration command to set the interface's ability to receive and send pause frames to on, off, or desired. The default flow control state for Gigabit Ethernet ports is receive off and send desired. These rules apply to flow control settings on the device: • receive on (or desired) and send on: Flow control operates in both directions; both the local and the remote devices can send pause frames to show link congestion. • receive on (or desired) and send desired: The port can receive pause frames and can send pause frames if the attached device supports flow control. • receive on (or desired) and send off: The port cannot send pause frames but can operate with an attached device that is required to or can send pause frames; the port can receive pause frames. 78-11380-10 Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide 11-13