Cisco 5510 Quick Start Guide - Page 30

Connecting Interface Cables and Verifying Interface Connectivity Chapter 5 Installing the ASA 5585-X Make sure the PC is configured to obtain an IP address using DHCP. (By default, the ASA is configured to act as the DHCP server for the management PC; therefore the ASA assigns the management PC an IP address from a pool.) Note If you want to use the CLI, connect your PC to the console port and see the CLI configuration guide for more information. Step 2 Connect your networks to the appropriate ports. If you are using the fiber ports, you need an SFP+ module for 10-Gigabit Ethernet (a license may be required) or an SFP module for Gigabit Ethernet. (SFP or SFP+ modules are not included.) Note The ASA 5585-X with SSP-10 and SSP-20 include 2 SFP/SFP+ and 8 copper Gigabit Ethernet ports (as shown in the following figure). The ASA 5585-X with SSP-40 and SSP-60 include 4 10-Gigabit Ethernet and 6 Gigabit Ethernet ports. See the Cisco ASA 5585-X Adaptive Security Appliance Hardware Installation Guide for more information. 300016 1 2 SFP1 SFP0 7 6 5 4 3 2 1 0 1 MGMT 0 0 1 USB PWR BOOT ALARM ACT VPN PS1 PS0 HDD1 HDD0 AUX CONSOLE RESET SFP1 SFP0 7 6 5 4 3 2 1 0 1 MGMT 0 0 1 USB PWR BOOT ALARM ACT VPN PS1 PS0 HDD1 HDD0 AUX CONSOLE RESET 3 Management PC Unsecure Network Secure Network Cisco ASA 5580 Series Quick Start Guide 5-4 78-19753-01