Cisco 7609-S Configuration Guide - Page 98

Managing Security Contexts Chapter 4 Configuring Security Contexts Step 4 To enter the new URL, enter the following command: hostname(config)# config-url new_url The system immediately loads the context so that it is running. Reloading a Security Context You can reload the context in two ways: • Clear the running configuration and then import the startup configuration. This action clears most attributes associated with the context, such as connections and NAT tables. • Remove the context from the system configuration. This action clears additional attributes, such as memory allocation, which might be useful for troubleshooting. However, to add the context back to the system requires you to respecify the URL and interfaces. This section includes the following topics: • Reloading by Clearing the Configuration, page 4-34 • Reloading by Removing and Readding the Context, page 4-35 Reloading by Clearing the Configuration To reload the context by clearing the context configuration, and reloading the configuration from the URL, perform the following steps: Step 1 Step 2 Step 3 Step 4 To change to the context that you want to reload, enter the following command: hostname# changeto context name To access configuration mode, enter the following command: hostname/name# configure terminal To clear the running configuration, enter the following command: hostname/name(config)# clear configure all This command clears all connections. To reload the configuration, enter the following command: hostname/name(config)# copy startup-config running-config The FWSM copies the configuration from the URL specified in the system configuration. You cannot change the URL from within a context. 4-34 Catalyst 6500 Series Switch and Cisco 7600 Series Router Firewall Services Module Configuration Guide using ASDM OL-20748-01