Cisco 871W Hardware Installation Guide - Page 75
Verifying the Initial Configuration, What to Do Next - password
UPC - 746320958019
View all Cisco 871W manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 75 highlights
Chapter 5 Initial Configuration Verifying the Initial Configuration Step 3 Step 4 Step 5 Step 6 Press Return to display the Router> prompt. ... flashfs[4]: Initialization complete. Router> Enter privileged EXEC mode. Router> enable Router# For configuration using the CLI, see the applicable configuration procedures in the Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide. Verify the initial configuration. See the "Verifying the Initial Configuration" section for verification procedures. Verifying the Initial Configuration To verify that the new interfaces are operating correctly, perform the following tests: • To verify that the interfaces are operating correctly and that the interfaces and line protocol are in the correct state-up or down-enter the show interfaces command. • To display a summary status of the interfaces configured for IP, enter the show ip interface brief command. • To verify that you configured the correct hostname and password, enter the show configuration command. After you have completed and verified the initial configuration, you can configure your Cisco router for specific functions. What to Do Next For information and instructions on how to perform additional configurations for the router, see the Cisco 850 Series and Cisco 870 Series Access Routers Software Configuration Guide. OL-5331-01 Cisco 850 Series and Cisco 870 Series Access Routers Hardware Installation Guide 5-5