Cisco AIR-AP1230A-A-K9 Hardware Installation Guide - Page 87
Removing a 5-GHz Radio Module
UPC - 746320803500
View all Cisco AIR-AP1230A-A-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
Chapter 8 5-GHz Radio Module Upgrade Removing a 5-GHz Radio Module Step 3 Remove the 5-GHz access cover using the supplied Torx L-wrench (see Figure 8-1). Figure 8-1 1 5-GHz Radio Access Cover 21 74632 1 Access Cover Screws 2 Access Cover Removing a 5-GHz Radio Module To remove the 5-GHz radio module, follow these steps: Step 1 Step 2 Step 3 Remove all cables and power connections from the access point. Place the access point on a flat surface so that the unit is upright with the front end facing you. Unscrew the two mounting screws using the supplied Torx L-wrench (Figure 8-2). Figure 8-2 5-GHz Radio Module 1 1 2 3 74631 1 Mounting screws 2 5-GHz radio module antenna 3 Access point Note Do not attempt to remove the mounting screws from the module; they are captured in the module housing. OL-4310-05 Cisco Aironet 1200 Series Access Point Hardware Installation Guide 8-3