Cisco AIR-AP1230A-S-K9-RF Hardware Installation Guide - Page 91
Attaching the Compliance Label - air a k9
View all Cisco AIR-AP1230A-S-K9-RF manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 91 highlights
Chapter 8 5-GHz Radio Module Upgrade Installing a 5-GHz Radio Module Attaching the Compliance Label There are three places on the 1200 series access point dedicated to compliance labels, one for the product compliance label and two for the radio compliance labels. The label locations are shown in Figure 8-6. Figure 8-6 Access Point Compliance Label Locations 1 2 3 103640 1 Product compliance label 2 Radio compliance label 3 Radio compliance label The product compliance label always occupies the top space (location 1). The two spaces below the product compliance label (locations 2 and 3) contain the radio compliance labels. Whether or not locations 2 or 3 contain labels depends on how your access point is configured. For example, the access point could have two radio compliance labels (one for each radio device installed), or the access point could have only a product compliance label, depending on how it was ordered. Make sure that your access point has the correct labels after you install or upgrade its radio configuration so that it will be in compliance with regulations in your country. The AIR-MR21A and AIR RM22A radio upgrade kits ship with the following labels for the 1200 series access points: • 1200 series product compliance label (AIR-AP1210-x-K9) • 1200 series radio compliance label (AIR-RM21A-x-K9 or AIR-RM22A-x-K9) Table 8-1 shows where to place the labels on your 1200 series access point, based on the model you are upgrading. Follow these steps to place the labels correctly: OL-4310-05 Cisco Aironet 1200 Series Access Point Hardware Installation Guide 8-7