Cisco AIR-AP1252AG-E-K9 Hardware Installation Guide - Page 36
Powering Up the Access Point, Troubleshooting
View all Cisco AIR-AP1252AG-E-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Connecting the Ethernet and Power Cables Chapter 2 Installing the Access Point Powering Up the Access Point When power is applied to the access point, it begins a routine power-up sequence that you can monitor by observing the three LEDs on top of the access point. After you observe all three LEDs turning green to indicate the starting of the IOS operating system, the Status LED blinks green signifying that IOS is operational. When in an operational status, the Ethernet LED is steady green when no traffic is being passed and dark during periods when traffic is being passed. The sequence takes about 1 minute to complete. Refer to Chapter 9, "Troubleshooting," for LED descriptions. When the sequence is complete, you are ready to obtain the access point's IP address and perform an initial configuration. Refer to Chapter 3, "Configuring the Access Point for the First Time," for instructions on assigning basic settings to the access point. 2-10 Cisco Aironet 1200 Series Access Point Hardware Installation Guide OL-4310-05