Cisco AIR-LAP1310G-E-K9R Hardware Installation Guide - Page 56
Blinking Codes, Description, First, Digit, Second, Table 4-2
View all Cisco AIR-LAP1310G-E-K9R manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
Checking the LEDs on an Autonomous Access Point/Bridge Chapter 4 Troubleshooting Autonomous Access Points and Bridges The LED blinking error codes are described in Table 4-2. Table 4-2 LED Blinking Error Codes on an Autonomous Access Point/Bridge LED Ethernet Radio Blinking Codes First Digit Second Digit Description 2 1 Ethernet cable problem-verify that the cable is properly connected and not defective. This error might also indicate a problem with the Ethernet link. If the cable is connected properly and not defective, contact technical support for assistance. 1 2 Radio not detected-contact technical support for assistance. 1 3 Radio not ready-contact technical support for assistance. 1 4 Radio did not start-contact technical support for assistance. 1 5 Radio failure-contact technical support for assistance. 1 6 Radio did not flash its firmware-contact technical support for assistance. Cisco Aironet 1300 Series Wireless Outdoor Access Point/Bridge Hardware Installation Guide 4-4 OL-5048-06