Cisco ASR1004-10G-SHA/K9 Software Guide - Page 313
Problem, Solution, Incorrect clock limit, set or queue limit, disabled mode
View all Cisco ASR1004-10G-SHA/K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 313 highlights
Chapter 10 Synchronous Ethernet Support Configuring Synchronous Ethernet Table 10-3 Troubleshooting Scenarios (continued) Problem Incorrect clock limit set or queue limit disabled mode Solution • Verify that there are no alarms on the interfaces. Use the show network-clock synchronization detail RP command to confirm. Warning We recommend that you do not use these debug commands without TAC supervision. • Use the show network-clock synchronization command to confirm if the system is in revertive mode or nonrevertive mode and verify the nonrevertive configurations as shown in this example: RouterB#show network-clocks synchronization Symbols: En - Enable, Dis - Disable, Adis - Admin Disable NA - Not Applicable * - Synchronization source selected # - Synchronization source force selected & - Synchronization source manually switched Automatic selection process : Enable Equipment Clock : 1544 (EEC-Option2) Clock Mode : QL-Enable ESMC : Enabled SSM Option : GEN1 T0 : External R0 t1 esf Hold-off (global) : 300 ms Wait-to-restore (global) : 300 sec Tsm Delay : 180 ms Revertive : No Force Switch: FALSE Manual Switch: FALSE Number of synchronization sources: 2 sm(netsync NETCLK_QL_ENABLE), running yes, state 1A Last transition recorded: (src_rem)-> 1A (src_added)-> 1A (src_rem)-> 1A (src_added)-> 1A (ql_change)-> 1A (sf_change)-> 1A (force_sw)-> 1C (clear_sw)-> 1A (sf_change)-> 1A (sf_change)-> 1A Revertive : Yes