Cisco ASR1006 Deployment Guide - Page 34

Optional Minimal Site Survey Deployment • Contact Cisco WLAN Solution for the Cisco 1000 series lightweight access point mounting brackets and recommended telescoping stand screws. • Use duct tape and/or cable ties to assemble the telescoping stands, Cisco 1000 series lightweight access points, CAT-5 Ethernet cables, Ethernet power injectors, power inverter, external power supply, battery packs, and/or extension cords as shown in the following figure. Note Make sure you support the CAT-5 and power cables to remove harmful stress on the Cisco 1000 series lightweight access point connectors. Figure 7 Cisco 1000 Series Lightweight Access Point Tripod Test Assemblies AP AP CAT5 cable Power injector 110-220 VAC extension cord Power converter cable 110-220 VAC extension cord External power converter 135689 A. Power injector/AC power B. Power converter/AC power • Continue with "Positioning a Cisco 1000 Series Lightweight Access Point at Each Planned Location." Positioning a Cisco 1000 Series Lightweight Access Point at Each Planned Location This section assumes that you have determined the Cisco 1000 series lightweight access point locations as described in "Cisco 1000 Series Lightweight Access Point Placement." Refer to "Preparing Optional Cisco 1000 Series Lightweight Access Point Tripod Test Assemblies" for instructions on how to power the Cisco 1000 series lightweight access points at each planned location. Caution If you are using AC extension cords, make sure you use duct tape to avoid creating trip hazards. • Using the floor plans and/or maps from "Cisco 1000 Series Lightweight Access Point Placement Guidelines," place the Cisco 1000 series lightweight access point assemblies at or near the indicated locations. Deployment Guide: Cisco Aironet 1000 Series Lightweight Access Points 16 78-17279-01