Cisco C7200-I User Guide - Page 7
Configuring the Gigabit Ethernet Interface on the Cisco 7200-I/O-GE+E - o end
UPC - 746320365398
View all Cisco C7200-I manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 7 highlights
Cisco 7200-I/O-GE+E and Cisco 7200-I/O-2FE/E Input/Output Controllers Command Reference Configuring the Gigabit Ethernet Interface on the Cisco 7200-I/O-GE+E The following example configures the Gigabit Ethernet interface on the Cisco 7200-I/O-GE+E. The following commands are configured on slot 0, port 0. Router# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)# interface gigabitethernet 0/0 Router(config-if)# ip address 1.1.1.10 255.255.255.252 Router(config-if)# negotiation auto Router(config-if)# end Configuring Autonegotiation on the Cisco 7200-I/O-2FE/E The following example configures the Fast Ethernet interface on the Cisco 7200-I/O-2FE/E for fully enabled autonegotiation: Router# configure terminal Enter configuration commands, one per line. End with CNTL/Z. Router(config)# interface fastethernet 0/0 Router(config-if)# duplex auto Router(config-if)# speed auto Command Reference This section documents new or modified commands. All other commands used with this feature are documented in the Cisco IOS Release 12.1 command reference publications. • interface gigabitethernet • negotiation • show controllers gigabitethernet • show interfaces gigabitethernet Cisco IOS Release 12.1(3a)E 7