Cisco CISCO2801 User Guide - Page 120
LED Type, LED Color, Message, Meaning, and Recommended Action, Table 3
View all Cisco CISCO2801 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 120 highlights
System Messages The terminal should display one of the following prompts: Router> (indicates the user EXEC command mode) or Router# (indicates the privileged EXEC command mode) The Cisco IOS software checks the system condition once every 30 seconds. If the condition still exists, the error message appears again; if the error condition has cleared, a recovery message appears. Table 3 describes system error and recovery messages and LED conditions that might accompany them. Note Table 3 does not provide a complete list of system LED conditions. (For all LED conditions that can occur in your router, see the "Reading System LEDs" section on page 4 and the "Reading Port and Module LEDs" section on page 6.) Table 3 System Error and Recovery Messages LED Type SYS PWR LED Color Amber Message, Meaning, and Recommended Action Error: %SYS-1-OVERTEMP: System detected OVERTEMPERATURE condition. Please resolve cooling problem immediately! Explanation: The router is operating at an abnormally high temperature, possibly caused by one or more of the following conditions: • Fan failure • Air conditioner failure in the room • Air blockage to cooling vents Recovery: Make sure that the room temperature is not too high and that airflow to the router is not blocked. See also the "Site Environment" section on page 4 and the "Equipment Racks" section on page 5. If this condition persists, the environmental monitor might shut down the system. Call your Cisco technical support representative for assistance, if necessary. When the error condition is resolved, the SYS PWR LED changes to green, and the following informational message appears: %ENVMON-3-OVERTEMP_OK: System temperature normal Note These messages are not supported on the Cisco 2801. Troubleshooting Cisco 2800 Series Routers 8 OL-5789-01