Cisco CISCO881G-G-K9 Hardware Installation Guide - Page 31
Connecting a Server, PC, or Workstation,
UPC - 882658250385
View all Cisco CISCO881G-G-K9 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 31 highlights
Chapter 2 Installation Installing Your Router Connecting a Server, PC, or Workstation Before connecting the server, PC, or workstation, refer to Table 2-2 to determine how to set the router HUB/NO HUB or TO HUB/TO PC button. Ensure that your device has a 10- or 10/100-Mbps NIC. To connect one of these devices to a Cisco 800 series ISDN or IDSL router, follow the steps in Figure 2-2. Caution Always connect the yellow cable or an Ethernet cable to the yellow ports on the router. Do not connect the cable to an ISDN S/T or U port, to an IDSL port, or to an NT1. Connecting the cable to the wrong port or NT1 can damage your router. Figure 2-2 Connecting a Server, PC, or Workstation 1. Set HUB/NO HUB or TO HUB/TO PC button. Cisco 803 router HUB NO HUB ETHERNET 10 BASE T 0 1 2 3 Cisco 803 CONSOLE ISDN S/T PHONE 1 2 2. Connect cable to: • Yellow Ethernet port on Cisco 801, Cisco 802, or Cisco 802 IDSL router. • Any yellow port on Cisco 803, Cisco 804, or Cisco 804 IDSL router. PC ETH SER 0 OK LAN 11675 AUX 3. Connect other end of cable to server, PC, or workstation. To verify your connection, verify that one of the following LEDs is on after you have completed router installation: • LINK LED on the Cisco 801, 802, or 802 IDSL back panel. • LKØ, LK1, LK2, or LK3 LED on the Cisco 803 or Cisco 804 front panel. • ETHERNET 1, 2, 3, or 4 LED on the Cisco 804 IDSL front panel. If the LED is not on, see Table 3-2 in Chapter 3, "Troubleshooting." 78-5373-04 Cisco 800 Series Routers Hardware Installation Guide 2-9