Cisco CRS-1 Migration Guide - Page 83

Chapter 1 Migrating to a Cisco CRS-3 Carrier Routing System How to Migrate to a Cisco CRS-3 Carrier Routing System (4-Slot) Powering up the Replaced Fabric Card This section describes how to enable power back to the Fabric node, and verify that node is moved to Powered state. Prerequisites Software Requirements • Cisco IOS XR Software Release 4.0.0.T or later release (Cisco IOS XR Software Release 4.0.2 for multishelf nodes) • ROMMON 1.54 or later version Hardware Requirements • The LCC to be added must be prepared as described in the "Prerequisites for Upgrading to a Cisco CRS-3 Carrier Routing System" section on page 1-2. • The control network must be operational and connected to all chassis. • The power should be off for the FCC to be added. Restrictions None. SUMMARY STEPS 1. admin 2. configure 3. no hw-module power disable loc 0/SM0/SP 4. commit 5. Verify that power has been enabled to the Fabric Node (state is not UNPOWERED). 6. show platform Node 0/SM0/SP 0/SM1/SP 0/SM2/SP 0/SM3/SP Type FC-140G/S(SP) FC/S(SP) FC/S(SP) FC/S(SP) PLIM N/A N/A N/A N/A State PRESENT IOS XR RUN IOS XR RUN IOS XR RUN Config State PWR,NSHUT,MON PWR,NSHUT,MON PWR,NSHUT,MON PWR,NSHUT,MON Booting Up the Newly Migrated Cisco CRS-3 Fabric This section describes the process for booting up the new Cisco CRS-3 fabric. When the Cisco CRS-3 fabric node is powered on, The Route Processor (RP) will automatically boot the new fabric. Please wait for the boot process to complete. The node will transition from state MBI-BOOT to MBI-RUNNING as the software is being installed. OL-13669-03 Cisco CRS-1 Carrier Routing System to Cisco CRS-3 Carrier Routing System Migration Guide 1-73