Cisco RVS4000 User Guide - Page 21

Chapter 5 Setting Up and Configuring the Router Destination IP Address Enter the network address of the remote LAN segment. For a standard Class C IP domain, the network address is the first three fields of the Destination LAN IP, while the last field should be zero. Subnet Mask Enter the Subnet Mask used on the destination LAN IP domain. For Class C IP domains, the Subnet Mask is 255.255.255.0. Gateway If this Router is used to connect your network to the Internet, then your gateway IP is the Router's IP Address. If you have another router handling your network's Internet connection, enter the IP Address of that router instead. Hop Count This value gives the number of nodes that a data packet passes through before reaching its destination. A node is any device on the network, such as switches, PCs, etc. The maximum hop count value is 16. Show Routing Table Click this button to show the routing table established either through dynamic or static routing methods. Inter-VLAN Routing Inter-VLAN Routing Select Enable to allow packets to be routed between VLANs that are in different subnets. The default is Enable. Click Save Settings to save the Routing settings or click Cancel Changes to undo your changes. Setup > Time Setup > Time Set the local time Manually If you wish to enter the time and date manually, select this option, then select the Date from the drop-down fields and enter the hour, minutes, and seconds in the Time fields using 24-hour format. For example, for 10:00 pm, enter 22 in the hours field, 0 in the minutes field, and 0 in the seconds field. 4-Port Gigabit Security Router with VPN Set the local time using Network Time Protocol (NTP) Automatically If you wish to use a Network Time Protocol server to set the time and date, select this option, then complete the following fields. Time Zone Select the time zone for your location and your time setting is synchronized over the Internet. Auto Daylight Saving If your location observes daylight savings time, select the Enable option. User-defined NTP Server To specify a user-defined NTP server, select the Enable option, then enter the NTP Server's IP address in the NTP Server IP field. NTP Server IP If the User-defined NTP Server option is set to Enable, enter the IP address of the NTP server. Click Save Settings to save your settings or click Cancel Changes to undo your changes. Setup > IP Mode Setup > IP Mode IPv4 Only Select this option to use IPv4 on the Internet and local network. Dual-Stack IP Select this option to use IPv4 on the Internet and IPv4 and IPv6 on the local network. Then select how the IPv6 hosts will connect to the Internet: •• NAPT-PT This allows an IPv6-only host on your LAN to connect to IPv4-only hosts on the WAN using addresstranslation and protocol-translation (per RFC2766). •• 6to4 Tunnel This allows your IPv6 network to connect to other IPv6 networks via tunnels through IPv4 (per RFC3056). The remote router also needs to support 6to4. Click Save Settings to save your settings or click Cancel Changes to undo your changes. 14