Cisco WS-C2960-24-S Hardware Installation Guide - Page 42
Mounting the Switch in a Rack, Mounting the Catalyst 2960 Switch in a Rack
View all Cisco WS-C2960-24-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Installing the Switch Chapter 2 Switch Installation (24- and 48-Port Switches) Mounting the Switch in a Rack After the brackets are attached to the switch, use the four supplied number-12 Phillips machine screws to securely attach the brackets to the rack, as shown in Figure 2-8. Figure 2-8 Mounting the Catalyst 2960 Switch in a Rack 204618 SYST RPS STAT DUPLX SPEED MODE 1 1 Phillips machine screws After the switch is mounted in the rack, do these tasks to complete the installation: • Power on the switch. See the "Verifying Switch Operation" section on page 2-5. • Connect to a 10/100 or 10/100/1000 port, and run Express Setup. See the Catalyst 2960 Switch Getting Started Guide for instructions. • Connect to the front-panel ports. See the "Connecting to the 10/100 and 10/100/1000 Ports" section on page 2-14, the "Connecting to SFP Modules" section on page 2-18, and the "Connecting to a Dual-Purpose Port" section on page 2-20 to complete the installation. For configuration instructions about using the command-line interface (CLI) setup program, go to Appendix C, "Configuring the Switch with the CLI-Based Setup Program." 2-10 Catalyst 2960 Switch Hardware Installation Guide OL-7075-09