Cisco WS-C3750-24TS-E Hardware Installation Guide - Page 36
Enter, mdix auto, B-11 on B-9, Appendix D, Quick Setup By Using - s ios
UPC - 746320805153
View all Cisco WS-C3750-24TS-E manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 36 highlights
Starting Express Setup Chapter 1 Using Express Setup Re-enter 10.0.0.1 in the browser, and press Enter. • Did you connect a crossover instead of a straight-through Ethernet cable between an Ethernet port of the switch and the Ethernet port of the PC or workstation, as shown Figure 1-5. Note See Figure B-11 on page B-9 for instructions on identifying a crossover cable. Note On switches running Cisco IOS Release 12.1(14)EA1 or later, you can use the mdix auto command in the CLI to enable the automatic crossover feature. When the automatic crossover feature is enabled, the switch detects the required cable type for copper Ethernet connections and configures the interfaces accordingly. Therefore, you can use either a crossover or a straight-through cable for connections to a copper 10/100 or 10/100/1000 port on the switch, regardless the type of device on the other end of the connection. The automatic crossover feature is disabled by default. For configuration information for this feature, refer to the switch software configuration guide or the switch command reference. If not, reconnect the cable to the Ethernet port on the switch and PC or workstation. Wait 30 seconds before entering 10.0.0.1 in the browser. • Did you verify that POST successfully ran before starting Express Setup? If not, make sure that only the SYST and STAT LEDs are green before pressing the Mode button to begin Express Setup. Note The rest of this chapter explains how to configure a switch by using the Express Setup web page. To configure the switch by using the command-line interface (CLI)-based setup program, see Appendix D, "Quick Setup By Using the CLI-Based Setup Program." Catalyst 3750 Switch Hardware Installation Guide 1-8 78-15136-02