Cisco WS-C3750G-24TS-E1U Hardware Installation Guide - Page 146
Methods for Accessing the CLI, Accessing the CLI Through Express Setup (Uncon d Switch Only)
View all Cisco WS-C3750G-24TS-E1U manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 146 highlights
Methods for Accessing the CLI Appendix D Quick Setup By Using the CLI-Based Setup Program Methods for Accessing the CLI You can access the CLI by these methods: • Accessing the CLI Through Express Setup (Unconfigured Switch Only), page D-2 • Accessing the CLI Through the Console Port, page D-3 Accessing the CLI Through Express Setup (Unconfigured Switch Only) Note Express Setup is supported on switches running Cisco IOS Release 12.1(14)EA1 or later. If you are installing a new switch, refer to the Cisco IOS release label on the rear panel of the switch to determine the release. For switches running releases earlier than Cisco IOS Release 12.1(14)EA1, go to the "Taking Out What You Need" section on page D-4. You can access the CLI on an unconfigured switch by placing the switch in Express Setup mode and then connecting an Ethernet port of the switch to the Ethernet port of your PC or workstation. To put the switch into Express Setup mode, follow the steps described in these sections of Chapter 1, "Using Express Setup": • Taking Out What You Need, page 1-2 • Powering On the Switch, page 1-3 • Starting Express Setup, page 1-4 After the switch is in Express Setup mode, Telnet to the switch by using the IP address 10.0.0.1, and enter the setup user EXEC command. See these sections in this chapter to then configure the switch by using the CLI: • Entering the Initial Configuration Information, page D-10 • Completing the Setup Program, page D-11 After you have entered the configuration information for the switch, save it to Flash memory by using the write memory privileged EXEC command. Catalyst 3750 Switch Hardware Installation Guide D-2 78-15136-02