Cisco WS-C3750V2-24PS-S Hardware Installation Guide - Page 33
Step 1, Starting Express Setup
View all Cisco WS-C3750V2-24PS-S manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 33 highlights
Chapter 1 Using Express Setup Starting Express Setup Follow these steps to start the Express Setup program: Step 1 Step 2 Verify that no devices are connected to the switch. Press and hold the Mode button, as shown in Figure 1-4, until the four LEDs above the Mode button turn green. This takes approximately 3 seconds. Figure 1-4 Starting Express Setup SYST RPS MASTR STAT DUPLX SPEED STACK MODE 97173 1 1 Mode button Step 3 Release the Mode button. Note If all of the LEDs begin to blink after you press the Mode button, release it. Blinking LEDs mean that the switch has already been configured and cannot go into Express Setup mode. For more information, see the "Clearing the Switch IP Address and Configuration" section on page 4-2. Step 4 Connect the Ethernet cable (not included) to a 10/100 Ethernet port or small form-factor pluggable (SFP) module port on the front panel of the switch, as shown in Figure 1-5. 78-15136-02 Catalyst 3750 Switch Hardware Installation Guide 1-5