Cisco WS-SUP32-GE-3B System Message Guide - Page 207

MMLS Messages, MMLS-6

Page 207 highlights

Chapter 2 Messages and Recovery Procedures MMLS Messages MMLS Messages This section Multicast Multilayer Switching (MMLS) messages. MMLS-6 Error Message %MMLS-6-ADJ_ALLOC_FAILURE: Failed to allocate Adjacency for the multicast flow ([IP_address], [IP_address]) Explanation The system is unable to allocate an adjacency for the specified flow. The system will attempt the specified flow again. The flow is software switched until it is successfully installed in the hardware. The adjacency table utilization could be very high and might need to be brought down. Recommended Action Determine adjacency table utilization. Try removing some hardware-switched flows. Error Message %MMLS-6-BIDIR_ADJ_LIMIT_EXCEEDED: Failed to allocate Adjacency for Bidir Multicast shortcuts, exceeded limit of ([dec]), subsequent flows will be software switched. Explanation The system limit of maximum adjacencies for bidirectional shortcuts is exceeded. As a result, any new multicast flows will be switched by the software. Recommended Action The number of bidirectional multicast flows is too large to fit in the hardware. There is no workaround. Error Message %MMLS-6-FIB_LIMIT_EXCEEDED: Failed to allocate FIB entry, exceeded system limit of ([dec]) entries. Explanation The maximum FIB entry limit has been exceeded. FIB entries cannot be allocated by MMLS. Recommended Action The total number of multicast shortcuts is too large to fit in the FIB table. Subsequent shortcuts will be switched by the software. There is no workaround. Error Message %MMLS-6-MET_LIMIT_EXCEEDED: Failed to allocate MET entry, exceeded system limit of ([dec]) entries. Number of times MET limit is exceeded in the last 1 min : [dec] Explanation The maximum MET entry limit has been exceeded. MET entries cannot be allocated by MMLS. Recommended Action The total number of OIFs is too large to fit in the MET table. Subsequent shortcuts or OIFs will be switched by the software. There is no workaround. OL-11469-02 Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY 2-177

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
  • 44
  • 45
  • 46
  • 47
  • 48
  • 49
  • 50
  • 51
  • 52
  • 53
  • 54
  • 55
  • 56
  • 57
  • 58
  • 59
  • 60
  • 61
  • 62
  • 63
  • 64
  • 65
  • 66
  • 67
  • 68
  • 69
  • 70
  • 71
  • 72
  • 73
  • 74
  • 75
  • 76
  • 77
  • 78
  • 79
  • 80
  • 81
  • 82
  • 83
  • 84
  • 85
  • 86
  • 87
  • 88
  • 89
  • 90
  • 91
  • 92
  • 93
  • 94
  • 95
  • 96
  • 97
  • 98
  • 99
  • 100
  • 101
  • 102
  • 103
  • 104
  • 105
  • 106
  • 107
  • 108
  • 109
  • 110
  • 111
  • 112
  • 113
  • 114
  • 115
  • 116
  • 117
  • 118
  • 119
  • 120
  • 121
  • 122
  • 123
  • 124
  • 125
  • 126
  • 127
  • 128
  • 129
  • 130
  • 131
  • 132
  • 133
  • 134
  • 135
  • 136
  • 137
  • 138
  • 139
  • 140
  • 141
  • 142
  • 143
  • 144
  • 145
  • 146
  • 147
  • 148
  • 149
  • 150
  • 151
  • 152
  • 153
  • 154
  • 155
  • 156
  • 157
  • 158
  • 159
  • 160
  • 161
  • 162
  • 163
  • 164
  • 165
  • 166
  • 167
  • 168
  • 169
  • 170
  • 171
  • 172
  • 173
  • 174
  • 175
  • 176
  • 177
  • 178
  • 179
  • 180
  • 181
  • 182
  • 183
  • 184
  • 185
  • 186
  • 187
  • 188
  • 189
  • 190
  • 191
  • 192
  • 193
  • 194
  • 195
  • 196
  • 197
  • 198
  • 199
  • 200
  • 201
  • 202
  • 203
  • 204
  • 205
  • 206
  • 207
  • 208
  • 209
  • 210
  • 211
  • 212
  • 213
  • 214
  • 215
  • 216
  • 217
  • 218
  • 219
  • 220
  • 221
  • 222
  • 223
  • 224
  • 225
  • 226
  • 227
  • 228
  • 229
  • 230
  • 231
  • 232
  • 233
  • 234
  • 235
  • 236
  • 237
  • 238
  • 239
  • 240
  • 241
  • 242
  • 243
  • 244
  • 245
  • 246
  • 247
  • 248
  • 249
  • 250
  • 251
  • 252
  • 253
  • 254
  • 255
  • 256
  • 257
  • 258
  • 259
  • 260
  • 261
  • 262
  • 263
  • 264
  • 265
  • 266
  • 267
  • 268
  • 269
  • 270
  • 271
  • 272
  • 273
  • 274
  • 275
  • 276
  • 277
  • 278
  • 279
  • 280
  • 281
  • 282
  • 283
  • 284
  • 285
  • 286
  • 287
  • 288
  • 289
  • 290
  • 291
  • 292
  • 293
  • 294
  • 295
  • 296
  • 297
  • 298
  • 299
  • 300
  • 301
  • 302
  • 303
  • 304
  • 305
  • 306
  • 307
  • 308
  • 309
  • 310
  • 311
  • 312
  • 313
  • 314
  • 315
  • 316
  • 317
  • 318
  • 319
  • 320
  • 321
  • 322
  • 323
  • 324
  • 325
  • 326
  • 327
  • 328
  • 329
  • 330
  • 331
  • 332
  • 333
  • 334
  • 335
  • 336
  • 337
  • 338
  • 339
  • 340
  • 341
  • 342
  • 343
  • 344
  • 345
  • 346
  • 347
  • 348
  • 349
  • 350
  • 351
  • 352
  • 353
  • 354
  • 355
  • 356
  • 357
  • 358
  • 359
  • 360
  • 361
  • 362
  • 363
  • 364
  • 365
  • 366
  • 367
  • 368

2-177
Catalyst Supervisor Engine 32 PISA Cisco IOS System Message Guide, Release 12.2ZY
OL-11469-02
Chapter 2
Messages and Recovery Procedures
MMLS Messages
MMLS Messages
This section Multicast Multilayer Switching (MMLS) messages.
MMLS-6
Error Message
%MMLS-6-ADJ_ALLOC_FAILURE: Failed to allocate Adjacency for the
multicast flow ([IP_address], [IP_address])
Explanation
The system is unable to allocate an adjacency for the specified flow. The system will
attempt the specified flow again. The flow is software switched until it is successfully installed in
the hardware. The adjacency table utilization could be very high and might need to be brought down.
Recommended Action
Determine adjacency table utilization. Try removing some hardware-switched
flows.
Error Message
%MMLS-6-BIDIR_ADJ_LIMIT_EXCEEDED: Failed to allocate Adjacency for
Bidir Multicast shortcuts, exceeded limit of ([dec]), subsequent flows will be
software switched.
Explanation
The system limit of maximum adjacencies for bidirectional shortcuts is exceeded. As a
result, any new multicast flows will be switched by the software.
Recommended Action
The number of bidirectional multicast flows is too large to fit in the hardware.
There is no workaround.
Error Message
%MMLS-6-FIB_LIMIT_EXCEEDED: Failed to allocate FIB entry, exceeded
system limit of ([dec]) entries.
Explanation
The maximum FIB entry limit has been exceeded. FIB entries cannot be allocated by
MMLS.
Recommended Action
The total number of multicast shortcuts is too large to fit in the FIB table.
Subsequent shortcuts will be switched by the software. There is no workaround.
Error Message
%MMLS-6-MET_LIMIT_EXCEEDED: Failed to allocate MET entry, exceeded
system limit of ([dec]) entries. Number of times MET limit is exceeded in the last
1 min : [dec]
Explanation
The maximum MET entry limit has been exceeded. MET entries cannot be allocated by
MMLS.
Recommended Action
The total number of OIFs is too large to fit in the MET table. Subsequent
shortcuts or OIFs will be switched by the software. There is no workaround.