Cisco WS-X6K-S2-PFC2 Software Guide - Page 700

Configuring Multicast Router Ports and Group Entries Chapter 40 Configuring Multicast Services This example shows how to disable GMRP globally on the switch: Console> (enable) set gmrp disable GMRP disabled. Console> (enable) Configuring Multicast Router Ports and Group Entries These sections describe how to specify multicast router ports manually and configure multicast group entries: • Specifying Multicast Router Ports, page 40-20 • Configuring Multicast Groups, page 40-21 • Clearing Multicast Router Ports, page 40-21 • Clearing Multicast Group Entries, page 40-22 Specifying Multicast Router Ports When you enable IGMP snooping, the switch automatically learns to which ports a multicast router is connected. However, if desired, you can manually specify multicast router ports. To specify multicast router ports manually, perform this task in privileged mode: Step 1 Step 2 Task Manually specify a multicast router port. Verify the configuration. Command set multicast router mod/port show multicast router [mod/port] [vlan_id] This example shows how to specify a multicast router port manually and verify the configuration (the asterisk [*] next to the multicast router on port 3/1 indicates that the entry was configured manually): Console> (enable) set multicast router 3/1 Port 3/1 added to multicast router port list. Console> (enable) show multicast router IGMP disabled Port --------- 2/1 2/2 3/1 * 7/9 Vlan 99 255 1 2,99 Total Number of Entries = 4 '*' - Configured Console> (enable) 40-20 Catalyst 6000 Family Software Configuration Guide-Releases 6.3 and 6.4 78-13315-02