Clifford Arrow 3 Owners Guide - Page 9

Table of User-Selectable Features Feature Select 1 blank press 2 blank presses 3 blank presses 4 blank presses 1 D press Add a new remote control NOTE 1 Chirps: off/on (1/2 chirps) AutoArming: off/on NOTE 5 - Other vehicle's remote: arm/disarm (1 then 2 chirps) 2 D presses Personalized Siren Sounds*/** NOTE 2 NOT USED Lock upon AutoArming: off/on NOTE 6 - Other vehicle's remote: trunk release* (2 chirps) 3 D presses Play Personalized Siren Sounds*/**: Remote valet mode via trigger only/always (1/2 chirps) button combo + D: off/on AutoArming entry delay: off/on NOTE 6 - Other vehicle's remote: silent arm and disarm (3 chirps) 4 D presses Siren duration: 30/60/90sec.** AutoStart*: both off/both on/temp (1/2/3 chirps) only/battery only (1/2/3/4 chirps) FACT: off/on NOT USED 5 D presses AutoLock: off/on NOT USED NOT USED NOTE 6 - Other vehicle's remote: remote engine starting* (5 chirps) 6 D presses AutoUnLock: off/on Clear all remotes NOTE 3 NOT USED NOTE 6 - Other vehicle's remote: window rolldown/venting* (6 chirps) 7 D presses Reset all features (except remotes and valet code) to factory settings Set a new secret valet code NOTE 4 NOT USED NOTE 6 - Other vehicle's remote: remote valet mode (7 chirps) * Requires optional wiring or accessory; ask your Clifford Dealer for details. **Not available on European models in compliance with EC95/56 NOTE 1: Press the button of the new remote. You'll hear one chirp. Press the chirps to confirm that the new remote control has been added. button again. You'll hear two NOTE 2: This feature requires the optional Self-Powered SmartSiren 4. If so equipped, selection of this feature will cause the system to sound a few seconds of siren sound #1. Press the blank button to turn on this sound or the D button to turn it off. The system will then sound a few seconds of sound #2. Repeat: blank=ON, D=OFF for each of the six sounds. NOTE 3: You'll hear two chirps to indicate all remotes have been cleared from memory. You must now add new/existing remotes with the "Add new remote control" feature and/or the "Other vehicle's remote" feature. NOTE 4: Immediately PRESS THE BLANK BUTTON, THEN enter your new code, wait for the two chirps, then turn off the ignition (you'll hear 3 chirps to confirm program mode exit). You MUST now turn the ignition back on and then re-enter your new code. If the LED flashes on, your new code has been accepted. If the LED does not light, the two codes did not match and the system has reverted to your previous code. NOTE 5: Lets you arm/disarm with the remote control of a G4 system on your other vehicle(s). For instance, to set the D button of the other car's remote to arm and disarm this system, select column 4, row 1, then press the D button of the other car's remote (you'll hear one chirp). Immediately press the D button again (you will hear a 2-chirp confirmation). The D button of the other vehicle's remote will now arm/disarm this system. NOTE 6: The features in this column allow you to control your system with the remote control of a G4 system on your other vehicle(s). Just select the function you wish, then press the unused button or button combination on the other remote that you want to use to perform that function on this system (you will then hear a the chirps noted). NOTE: You must first set a button or button combination on the other car's remote that will arm/disarm the system (column 4, row 1) before these others will be accepted. Lifetime limited factory warranty terms & conditions Clifford vehicle security systems and accessories require professional installation by an Authorized Clifford Dealer. Unless the system is sold and installed by an Authorized Clifford Dealer, all product warranties and guarantees are void. (UK: This does not affect your statutory rights.) As the manufacturer, Clifford Electronics warrants to the original consumer purchaser, the system control unit and remote controls to be free from defects in material and workmanship for as long as you own the vehicle in which the system was originally installed. All other parts of the system and accessories to the system are warranted to be free from defects in material and workmanship for one (1) year from the date of purchase. Clifford Electronics will repair or replace, at its option and free of charge during the warranty period, any system component that proves defective in material or workmanship under normal installation, use, and service, provided the product is returned to our factory by an Authorized Clifford Dealer, transportation charges prepaid. Products returned to our factory must be accompanied by a photocopy of the purchase receipt. In the absence of such purchase receipt, the warranty period shall be one (1) year from the date of manufacture. Any damage to the product(s) as a result of misuse, abuse, neglect, accident, incorrect wiring, improper installation, destruction or alteration of the serial number, repair or alteration outside our factory, or any use violative of instructions furnished by us will void the warranty. This warranty is limited to defective parts and specifically excludes any incidental or consequential damages connected therewith. This warranty is not transferable. Clifford Electronics makes no warranty against theft. This warranty is not to be construed as an insurance policy against loss. Warranty on installation labor, removal and reinstallation charges are not the responsibility of Clifford Electronics, Inc. 9