Clifford Concept 550 Owners Guide - Page 34
adjusting the proximity sensor
View all Clifford Concept 550 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 34 highlights
adjusting the proximity sensor It is recommended that adjustments be performed away from fluorescent lighting, large metal structures, or confined areas that can affect the sensor field. The alarm will exit adjustment mode automatically 60 seconds after the last adjustment signal from the transmitter and revert to its previous settings. NOTE: You MUST exit using the ARM/DISARM button after programming to lock in the new settings! The proximity sensor field takes one to two minutes to settle after entering adjustment mode, so begin adjusting the sensor within 45 seconds and adjust it slowly so it has time to settle. After two minutes you will have a consistent field during adjustment testing. Each zone has 32 settings that are indicated by chirps that raise and lower in frequency as adjustments are made. Total adjustment time for this sensor should be five minutes or less. Read the following instructions thoroughly for a full understanding of how to properly adjust this sensor. 1. Disarm system 2. Transmit Channel 16. (Press 1 time) 3 times then z The LED will turn on and the siren will chirp 1 time. z Primary (full trigger) zone adjustment has now been entered. z Primary zone can now be adjusted. 3. Adjusting Primary Zone z Press of the remote control to increase sensitivity. © 2004 directed electronics, inc. 31