Clifford Concept 650 Owners Guide - Page 33

ultrasecure auto-immobiliser

Get Clifford Concept 650 PDF manuals and user guides View all Clifford Concept 650 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 33 highlights

PIN Code Confirmation Procedure Begin this procedure within 15 seconds of finishing the programming sequence or the new code will not be set. 1. Turn on the ignition. 2. Enter the new PIN code. 3. Press and hold for three seconds. z LED turns on: New PIN code is learned and programming is complete. z LED stays off: New PIN code is not learned and the system reverts to the old PIN code. Redo the programming sequence. ultrasecure auto-immobiliser The built-in dual circuit immobiliser autoimmobilises (arms automatically), 30 seconds after the ignition has been turned off. (This feature is a Thatcham and EC requirement and, therefore is not programmable.) auto-immobilisation sequence 1. Turn ignition off or disarm alarm 2. After 30 seconds the systems Immobilisation circuits activate and engage the starter and ignition interrupt 3. LED flashes at ½ normal speed 30

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
  • 37
  • 38
  • 39
  • 40
  • 41
  • 42
  • 43
30
PIN Code Confirmation Procedure
Begin this procedure within 15 seconds of finishing the programming
sequence or the new code will not be set.
1.
Turn on the ignition.
2.
Enter the new PIN code.
3.
Press and hold
for three seconds.
LED turns on: New PIN code is learned and program-
ming is complete.
LED stays off: New PIN code is not learned and the sys-
tem reverts to the old PIN code. Redo the programming
sequence.
ultrasecure auto-immobiliser
The built-in dual circuit immobiliser autoimmobilises (arms automatical-
ly), 30 seconds after the ignition has been turned off. (This feature is a
Thatcham and EC requirement and, therefore is not programmable.)
auto-immobilisation sequence
1.
Turn ignition off or disarm alarm
2.
After 30 seconds the systems Immobilisation circuits activate
and engage the starter and ignition interrupt
3.
LED flashes at ½ normal speed