Clifford Concept 650MkII Owners Guide - Page 24

G919730P_01-07.qxd 1/12/07 3:39 PM Page 21 manual programming instructions It is a good idea to document changes by taking note of all feature changes made in programming mode. To enter the User Selectable Features programming: 1. Ignition on - Turn the ignition to the run position or start the engine. 2. Hold/Chirp/Release - Press and hold until a chirp is heard and the LED turns on, then release the button. You have now entered the feature selection position of the User Selectable Features grid. 3. Column select - Press the same number of times as the desired column. After a pause the siren will chirp the same number of times as the selected column for confirmation. 4. Feature select - Press the same number of times as the desired feature. The siren will chirp with each press. The feature can now be changed using the remote control. 5. Feature change - Press on the transmitter. If the sys- tem chirps once, the feature has just turned off; if the sys- tem chips twice, the feature has just turned on. If the fea- ture has more than two settings, continue pressing on the transmitter to toggle through the settings. You can advance to any feature in the same column by pressing within 60 seconds; to program a feature in a different column begin at step 4 within 60 seconds. note: Refer to the Feature Descriptions sections of this guide for important notes and descriptions of the system features and programming. 6. Exit programming - To exit programming mode turn the ignition off or wait 60 seconds without pressing the PlainView 2 Valet switch. The siren will chirp three times to indicate pro- © 2007 directed electronics 21