Clifford Sabre 2 Owners Guide - Page 15

Feature Factory setting # of momentary presses Secondary action Program completion confirmation Result Add a new remote to channel 3 - (silent arm/disarm) Button 3/channel 3 code of 13 Press remote control button 3 3 chirps the new remote control has been memorized Erase all channels - 15 All remote control codes - 2 chirps have been erased; program in new remote control(s) Valet Code 2 16 See Setting your own secret valet code on page 9. Example : To change the AutoArming feature from its factory setting of "on" to "off," you would do the following: • Turn the ignition key to the ON position. • Enter your valet code, then immediately tap and release the momentary side of the PlainView switch 4 times (you'll hear a chirp each time you press to help you count to the total of 4 chirps). • Wait 3 seconds. The system will sound one more chirp to confirm that the AutoArming setting is now off (1 chirp = off, 2 chirps = on). • Turn the ignition off. That's all there is to it! To change the AutoArming setting back, just repeat the procedure. Adding new remote controls For other drivers in your family, or if you wish to control Clifford systems on your other cars with the same remote control, you can buy additional remote controls from any Clifford Dealer (or call our Customer Service Department at 800-824-3208) and program them into the system yourself. Each Sabre II will respond to as many as four 3-channel ACG and/or 12-channel ACG remote controls. To add a new remote control to the system, use the procedures noted in the User-selectable features section on page 13 and above. 14