Cobra 29 LX User Manual - Page 7

Operation Operation Calibrate for SWR continued Note When switched to SWR mode the meter reading should ideally be as far to the left as possible. Anything over 3 is not acceptable. A slight antenna height adjustment (higher or lower) may be required. Repeat recalibration steps. NB /ANL SWR 1.5 2 3 CAL S/ RF RF RX SWR SWR /CAL VOL SIG 1 3 5 7 9 +30dB MENU PU SH ENTER SQ DYNAMIKE MEM OFF MIN M 5 . .Release.the.PTT.button,.press.and.release.the. S/RF-SWR CAL.button.to.the.SWR.position.. Then.press.the.PTT.button.to.read.the.SWR. reading. 6 . .Repeat.the.same.steps.two.through.five.on. Channel.1.and.40..This.will.check.SWR.for.all. channels. To Receive To Receive NB /ANL NB/ANL SWR 1.5 2 3 CAL ANL S/ RF S/RF RF RX SWR SWR /CAL CAL SIG 1 3 5 7 9 +30dB MENU PU SH ENTER VOL SQ DYNAMIKE MEM W OFF MIN MIN 1 ..Rotate.the.On/Off Volume.knob.clockwise.. The.RX.icon.will.be.displayed. 12 Selecting A Channel RX F SIG 1 3 5 7 9 +30dB DYNAMIKE MENU PU SH ENTER MEM RF GAIN DEL Selecting A Channel MIN MIN MAX . Unit.should.be.in.CB.mode..Rotate.channel 1 selector.clockwide.or.counter-clockwise.to. select.desired.channel. S-Meter Swings.proportionately.to.strength.of.incoming. signal.when.receiving. S-Meter SWR 1.5 2 3 S/RF RF CAL RX VOL SIG 1 SQ 3 5 7 9 +30dB DYNAMIKE MENU PU SH EN 1 ..The.S/RF-SWR-CAL.switch.must.be.in.the.S/RF. setting.to.read.the.meter. 13