Cobra CPI 1575 CPI1575_MANL - Page 6
Mounting, Installation, Requirements - 3000 watt
View all Cobra CPI 1575 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 6 highlights
10275_CPI1575_PH3 8/14/07 8:38 AM Page 6 Intro Operation Customer Assistance Warranty Intro Operation Customer Assistance Warranty Installation Installation Requirements Secondary Icons InstallaInsttailolatnion RequiremenNtostes • The Secondary Icons inverter must be installed in an area that meets all of the following requirements: A. Dry Do not place in an area where water can drip or splasNhoticoen the iCnavuetiornter. Warning B. Cool Ambient air temperature should be between 30°F and 105°F (0°C and 40°C). The cooler the better. Intro Operation Customer Assistance Warranty Installation Notes Mounting Installation Secondary Icons Notice Caution Installation Notes WARNING This unit contains components which can produce arcs or sparks. To prevent fire Woarrniengxplosion, do not install in compartments containing a battery or flammable materials, or in a location which requires ignition protected equipment. Notice Caution Warning WARNING This unit is suitable for installation in negative ground applications only. Do not attempt to install to a positive ground application. C. Ventilate Allow at least one inch (three cm) of clearance around the inverter for proper airflow. Make sure that ventilation openings on the ends of the unit are not obstructed. D. Safe Do not install the inverter in the same compartment as a battery or in any compartment that contains flammable liquids such as gasoline. on Customer Assistance EW.arraCntylose to Battery Install unit as close to battery as possible (without being in the same compartment) to minimize the length of cable required to connect the inverter to on Notesthe battery. It is better and cheaper to run longer AC wires than longer DC wires (cables). Mounting • To mount your inverter: 1. Place the inverter on a flat surface with the mounting bCrPaI c1k5e7t5against the mounting surface. DC TO AC INVERTER • 1500 watts continuous • 3000 watts peak Mounting Brackets • 5V usb output 2. Mount to secure surface using mounting hardware that is corrosion resistant (not included). CAUTION To avoid fire, do not cover or obstruct ventilation openings. Do not install e Caution Warning inverter in a zero-clearance compartment. Overheating may result. Mounting Hardware CAUTION The inverter must only be connected to batteries with a nominal output voltage of 12 volts. It will not work with a 6 volt battery, and will be damaged if it is connected to a 16 volt battery. The inverter can be mounted horizontally or vertically. If mounted vertically, neither end of the unit should be at the top (to avoid foreign material from falling or settling into the unit). 6 Nothing Comes Close to a Cobra™ 7