Cobra CXT400 CXT400_MANL - Page 10

Operation Mode Functions Channel Buttons 3. Press the Talk button to return to Standby mode on the selected memory location. A memory location can be reprogrammed at any time it is displayed. Press the Enter/Hi•Low button to begin. While recalling a stored memory location, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions. Mode/Lock Button Memory Icon To de-program a memory location: 1. Press the Mode/Lock button until the Memory icon and the memory location flash on the display. 2. Press the Channel Up or Channel Down button to select the memory location (0 through 9). Channel Buttons If a location has been programmed before, its associated channel/privacy code will be shown on the display. Enter/Hi-Low Button Channel 0 3. Press the Enter/Hi•Low button. The channel numbers will flash on the display. 4. Press the Channel Up or Channel Down button to select Channel 0. 5. Choose one of the following: a. Press the Enter/Hi•Low button to enter the channel/privacy code in the selected memory location and return to the beginning of memory location options. 14 Introduction Operation Customer Assistance Warranty b. Press the Mode/Lock button to enter the channel/privacy code in the selected memory location and proceed to other functions on the channel/privacy code displayed before you entered mode functions. While de-programming a memory location, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel/privacy code displayed before you entered mode functions. Channel Scan • Your microTALK radio can automatically scan channels. Mode/Lock Button To scan channels: 1. Press the Mode/Lock button until the Scan icon and the channel numbers flash on the display. Scanning Channels 2. Press the Channel Up or Channel Down button to begin scanning channels. The radio ignores specific privacy codes while scanning channels. Channel Buttons The Scan icon will continue to be displayed when scan is on. Your radio will continue to scan all channels and stop if an incoming transmission is detected. Your radio will remain on that channel for 10 seconds. While setting channel scan, if you do not press any buttons for 15 seconds, your radio will automatically return to Standby mode on the channel or channel/privacy code displayed before you entered mode functions. During channel scan (while receiving an incoming transmission), you can choose from the following: a. Press and hold the Talk button to communicate on that channel. Your radio will remain on that channel and return to Standby mode. b. Press the Channel Up or Channel Down button to resume scanning channels. 15