Compaq 278800-004 Deskpro Personal Computers Service Reference Guide - Page 52
-213, Screen Message, Beeps, Probable Cause, Recommended Action
View all Compaq 278800-004 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
POST Error Messages Continued Screen Message 164-Memory Size Error Beeps* 2S Probable Cause Memory configuration is incorrect. 183-Invalid Processor Jumper Setting 201-Memory Error 2S None System board jumper improperly set. RAM failure. 202-Memory Type Mismatch None 207-ECC Corrected Single 2S Bit Errors in DIMM/SIMM Pair(s) X,X,... in Memory Socket(s) y,y Memory modules do not match each other. Single Bit ECC error. Recommended Action 1. Run Computer Setup (F10 Setup) or Windows utilities. 2. Make sure memory module(s) (if any) are installed properly. 3. Verify proper memory module type. Reset system board jumpers to match processor and bus speeds. 1. Run computer Setup (F10 Setup) or Windows utilities. 2. Ensure memory and continuity modules are installed correctly. 3. Verify proper memory module type. 4. Remove and replace memory module(s) one at a time to isolate faulty module. 5. Replace the faulty memory module(s). 6. If error persists after replacing memory modules, replace the system board. Replace memory modules with matched sets. 1. Verify proper memory module type. 2. Try another memory socket. 3. Replace memory module if problem persists. 213-Incompatible DIMM 2S Module in DIMM Socket(s) X,X, X * L = Long, S = Short A DIMM module in DIMM 1. Verify proper memory module socket identified in the error type. message is missing critical SPD information, or is incompatible with the chipset. 2. Try another memory socket. 3. Replace DIMM with a module conforming to the SPD standard. continued D-2 POST Error Messages