Compaq 3000R Compaq 4000/7000 Racks Installation Guide - Page 11

Chapter 1 Introduction CAUTION If this HP NetServer is not installed according to these instructions, damage to the HP NetServer or accessories may result. Damage due to improper installation is not covered by the HP Warranty. Observe the precautions listed in this section to maintain the HP NetServer's reliability. When the HP NetServer LXr 8000 or 8500 is installed in a Compaq rack enclosure, certain requirements must be addressed to assure that the needs of the HP NetServer are met. These requirements are: • The HP NetServer is installed in a Compaq model 4000-series or 7000-series rack enclosure. • If you choose to use a door on this enclosure, only a Compaq model 4000-series or 7000-series door may be used. No other door may be used. The enclosure may be used with the door open or removed. It may also be used with the door closed if the Compaq rack-optimized front bezel, control panel bezel, and LCD cover are installed. • Mass storage devices listed in the Tested Products List (located on the HP NetServer Navigator CD-ROM) are used exclusively in the HP NetServer. • Use HP rack accessories. (HP rack accessories are not optimized for Compaq rack enclosures.) Compaq rack accessories have not been tested with HP NetServer products, but components such as monitors, keyboards, switchboxes, and power distribution units (PDUs) often work. NOTE This HP NetServer will not work with Compaq PDUs; the power connectors are incompatible. An appropriate PDU must be ordered. • Use APC® uninterruptible power supplies (UPS) with HP NetServers. APC offers mounting kits for Compaq rack enclosures. This HP NetServer is not supported in a rack enclosure under circumstances other than those listed above. See the "Warranty and Support" section of this document for additional support considerations. 7