Compaq 620 Compaq 320, 321, 420, 421, 620 and 621 Notebook PCs HP 420 and 620 - Page 107
Remove the Phillips PM2.0×3.0 screw, Phillips PM2.0×3.0 screw
View all Compaq 620 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 107 highlights
2. Remove the Phillips PM2.0×3.0 screw (1) that secures the board to the base enclosure, disconnect the audio ZIF connector and remove the flat-ribbon cable (2) from the system board. 3. Remove the optical drive extender on the 35.6-cm (14.0-in) computer by first removing the Phillips PM2.0×3.0 screw (1) that secures the extender to the base enclosure. NOTE: 33.8-cm (13.3-in) computers do not use an optical drive extender. 4. Lift the system board slightly and then pull the extender straight out (2) from the system board. 5. Release the RJ-11 cable from the cable routing area, lift the connector from the base enclosure (1), and disconnect the connector (2) from the system board. 6. Lift the system board at an angle (3) and disconnect the main battery cable (4) from the bottom of the board. Component replacement procedures 99