Compaq Armada e500s Compaq ArmadaStation EM Maintenance and Service Guide - Page 60
Reverse the removal procedure described above to install the power supply., remove the power supply.
View all Compaq Armada e500s manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 60 highlights
7. If a half-height device is installed in the half-height bay, disconnect the half height bay power supply cable from the half-height device (Figure 5-30). 8. Partially remove the power supply from the base cover. 9. Route the half-height bay power supply cable through the opening in the backplane . 10. Remove the power supply from the base cover . NOTE: In the illustration below, the half-height device is shown removed from the expansion base. In reality, it is not necessary to remove the half-height device to remove the power supply. Figure 5-30. Removing the Power Supply Reverse the removal procedure described above to install the power supply. 5-30 Removal and Replacement Procedures
5-30
Removal and Replacement Procedures
7. If a half-height device is installed in the half-height bay, disconnect the
half height bay power supply cable from the half-height device
(Figure 5-30).
8. Partially remove the power supply from the base cover.
9. Route the half-height bay power supply cable through the opening in the
backplane
.
10. Remove the power supply from the base cover
.
NOTE:
In the illustration below, the half-height device is shown removed from the
expansion base. In reality, it is not necessary to remove the half-height device to
remove the power supply.
Figure 5-30.
Removing the Power Supply
Reverse the removal procedure described above to install the power supply.