Compaq DL320 Deployment Guide - Page 4

Deploying ProLiant DL320 and DL360 Servers into Telecommunication (Telco) Racks 4 Following the guidelines in this document will minimize planning and installation time; however, do not use this document as your sole source of information for the rack installation. Other rack installation references include: • Compaq Third-Party Rack Option Kit installation guide (poster included with each kit). • "Compaq Ultra-Dense Server Deployment Solutions Overview," white paper available at www.compaq.com • Compaq Rack Builder Pro design and planning software utility, available for download from the Compaq website at www.compaq.com/racks • Product-specific user guides and manuals Rack Warnings This document should be used only as an information source for planning your deployment. Avoid personal injury and equipment damage by following accepted safety practices. WARNING: Ensure proper floor support. Deployment of ultra-dense servers, related equipment, and cables exceeds 1,800 pounds for a Compaq ProLiant DL360 single 42U rack and 1,700 pounds for a ProLiant DL320 single 42U rack. WARNING: Be aware of the center of gravity and tip hazard. Compaq recommends that the rack footings extend 10 inches from the front and back of any Compaq rack 22U or higher. Adequate stabilization measures are required. Ensure that the entire rack assembly is properly secured and that all personnel are trained in proper maintenance and operation procedures. Tip hazards include personal injury and death. CAUTION: Ensure your installation has adequate power supply and branch circuit protection. CAUTION: Thermal dissipation requirements of an ultra-dense server deployment mandate minimum unrestricted airspace of 3 inches in both the front and the rear of each Compaq ProLiant DL320 and ProLiant DL360 server. 13NS-1000A-WWEN