Compaq Evo D500 Hardware Reference Guide Compaq Evo Desktop Family Convertible - Page 25
Installing Additional Memory, DIMMs
View all Compaq Evo D500 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 25 highlights
Hardware Upgrades Installing Additional Memory The computer comes with synchronous dynamic random access memory SDRAM) dual inline memory modules (DIMMs). DIMMs The memory sockets on the Intel 845 chipset-based system board can be populated with industry-standard DIMMs. These memory module slots are populated with at least one preinstalled memory module. To achieve the maximum memory support, you may be required to replace the preinstalled DIMM with a higher capacity DIMM. For proper system operation, the DIMMs must be industry-standard 168-pin, unbuffered PC133-compliant SDRAM DIMMs, depending on the model. The SDRAM DIMMs must support CAS Latency 2 or 3 (CL = 2 or CL = 3). They must also contain the mandatory Joint Electronic Device Engineering Council (JEDEC) Serial Presence Detect (SPD) information. DIMMs constructed with x4 SDRAM are not supported; the system will not start using unsupported DIMMs. CAUTION: Some models support ECC memory and some support non-ECC memory. For those systems that do support ECC, Compaq does not support mixing ECC and non-ECC memory. Doing so will cause the system to blink the NUMLOCK LED on the keyboard continuously and, if a speaker is installed in the system, there will be a short beep followed by 2 long beeps. In addition, the system will not boot the operating system. Hardware Reference Guide 2-7