Compaq L2206tm User Guide - Page 23

Operating the touch screen, Installing the touch software, Microsoft Windows 7/Vista/XP (plug - touch not working

Get Compaq L2206tm PDF manuals and user guides View all Compaq L2206tm manuals
Add to My Manuals
Save this manual to your list of manuals

Page 23 highlights

4 Operating the touch screen Installing the touch software Microsoft Windows 7/Vista/XP (plug and play) NOTE: Refer to Connecting the cables on page 7 for instructions on connecting the USB cable. When you connect the USB cable between the monitor and a computer running Windows 7, Windows Vista, or Windows XP, the touch driver software will automatically install. The driver software may take a minute to install, and for Windows 7 and Windows Vista a message will display on the monitor screen indicating that the driver software has been installed successfully. After the touch driver software is installed, you can select, launch, and drag objects using the touch screen. To make a selection, touch the screen. NOTE: For Windows XP, the touch driver loads as an input device, so there will be no message verifying the driver installation. NOTE: Multi-touch gestures are supported in Windows 7 Home Premium, Professional, Enterprise, and Ultimate operating system editions only. Multi-touch is not supported in Windows 7 Home Basic or Starter editions, Windows Vista, or Windows XP. NOTE: If touch control does not begin to work within 20 seconds, you should verify that the touch driver is installed. To verify that the touch driver is installed: ● Windows 7-Select Start > Control Panel > System and Security > System, and ensure that Pen and Touch: Touch Input Available with 2 Touch Points is listed in the System section. ● Windows Vista-Select Start > Control Panel > Mobile PC > Pen and Input Devices. If the Touch tab appears, touch input is available. Installing the touch software 17

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
  • 21
  • 22
  • 23
  • 24
  • 25
  • 26
  • 27
  • 28
  • 29
  • 30
  • 31
  • 32
  • 33
  • 34
  • 35
  • 36
4
Operating the touch screen
Installing the touch software
Microsoft Windows 7/Vista/XP (plug and play)
NOTE:
Refer to
Connecting the cables
on page
7
for instructions on connecting the USB cable.
When you connect the USB cable between the monitor and a computer running Windows 7, Windows
Vista, or Windows XP, the touch driver software will automatically install. The driver software may
take a minute to install, and for Windows 7 and Windows Vista a message will display on the monitor
screen indicating that the driver software has been installed successfully. After the touch driver
software is installed, you can select, launch, and drag objects using the touch screen. To make a
selection, touch the screen.
NOTE:
For Windows XP, the touch driver loads as an input device, so there will be no message
verifying the driver installation.
NOTE:
Multi-touch gestures are supported in Windows 7 Home Premium, Professional, Enterprise,
and Ultimate operating system editions only. Multi-touch is not supported in Windows 7 Home Basic
or Starter editions, Windows Vista, or Windows XP.
NOTE:
If touch control does not begin to work within 20 seconds, you should verify that the touch
driver is installed.
To verify that the touch driver is installed:
●
Windows 7—Select
Start > Control Panel > System and Security > System
, and ensure that
Pen
and Touch: Touch Input Available with 2 Touch Points
is listed in the
System
section.
●
Windows Vista—Select
Start > Control Panel > Mobile PC > Pen and Input Devices
. If the
Touch
tab appears, touch input is available.
Installing the touch software
17