Compaq ML330 Installation Guide - Page 121
Table D-6, System Cannot Load SmartStart, Possible Cause, Possible Solution, IMPORTANT
UPC - 720591492960
View all Compaq ML330 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 121 highlights
Server Specific Troubleshooting Table D-6: System Cannot Load SmartStart continued Possible Cause Possible Solution The CD-ROM drive is not installed properly. The CD-ROM drive cable is not connected properly. 1. Power down the server. 2. Be sure the CD-ROM drive is installed properly. 3. Be sure the CD-ROM is cabled to the back of the CD-ROM drive and the system board. For connection information, refer to the HP ProLiant ML330 Generation 3 Server Maintenance and Service Guide. If the cable is not the problem, refer to the Servers Troubleshooting Guide for other options. The CD-ROM drive is not set as a bootable device. 1. Press the F9 key to run the ROM-Based Setup Utility (RBSU). 2. Set defaults and exit the utility. 3. Rerun RBSU to check the system configuration. For complete instructions on the use of RBSU, refer to Chapter 5, "Server Configuration and Utilities," or refer to the HP ROM-Based Setup Utility User Guide. The diskette in the diskette drive is preventing the system from loading. Remove the diskette. Existing software is causing conflict. 1. Clear the NVRAM and boot drives in RBSU. 2. Reinstall the operating system. IMPORTANT: Clearing NVRAM removes user data from the boot drives. To clear NVRAM and erase the boot drives, select the Advanced Options menu in RBSU, and then select Erase NVRAM/Boot Space Disk. D-10 HP ProLiant ML330 Generation 3 Server Setup and Installation Guide