Compaq ProLiant 400 ProLiant Server Troubleshooting Guide - Page 266
Refer to SCSI Hot-Plug Hard, Run the Upgrade Utility
View all Compaq ProLiant 400 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 266 highlights
ADU Error Messages Table D-1: Array Diagnostic Utility (ADU) Error Messages continued Message Description Recommended Action SCSI Port X, Drive ID Y...S.M.A.R.T. predictive failure errors Have been detected in the factory Monitor and Performance data. SOLUTION: Please replace this drive when conditions permit. A predictive failure warning for this hard drive has been generated, indicating that a drive failure is imminent. Replace this drive at the earliest opportunity. Refer to "SCSI Hot-Plug Hard Drives" in Chapter 2 before performing this operation. SCSI Port X, Drive ID Y...S.M.A.R.T. predictive failure errors Have been detected in the since power Monitor and Performance data. A predictive failure warning for this hard drive has been generated, indicating a drive failure is imminent. Replace this drive at the earliest opportunity. Refer to "SCSI Hot-Plug Hard Drives" in Chapter 2 before performing this operation. SOLUTION: Please replace this drive when conditions permit. SCSI Port X, Drive ID Y was replaced on a good volume: (failure message) ADU found this drive was replaced, even though there was no problem with the volume. No action needs to be taken. Set configuration command issued The configuration of the array controller has been updated. The array accelerator board may remain disabled until it is reinitialized. Run the server setup utility to reinitialize the array accelerator board. Soft Firmware Upgrade required ADU has determined that your controller is running firmware that has been soft upgraded by the Upgrade Utility. However, the firmware running is not present on all drives. This could be caused by the addition of new drives in the system. Run the Upgrade Utility to place the latest firmware on all drives. continued D-16 HP Servers Troubleshooting Guide