Craftsman 11580 Operation Manual - Page 14

Installingbits

Get Craftsman 11580 - C3 19.2 Volt Hammer PDF manuals and user guides View all Craftsman 11580 manuals
Add to My Manuals
Save this manual to your list of manuals

Page 14 highlights

INSTALLINGBITS See Figures 10- 11. [] Lock the switch trigger by placing the direction of rotation selector in the center position. [] Open or close the chuck jaws to a point where the opening is slightly larger than the bit size you intend to use. Also, raise the front of the drill slightly to keep the bit from falling out of the chuck jaws. [] Insert the drill bit. [] Tighten the chuck jaws on the drill bit. CHUCK JAWS UNLOCK (RELEASE) CHUCK COLLAR _ WARNING: Make sure to insert the drill bit straight into the chuck jaws. Do not insert the drill bit into the chuck jaws at an angle then tighten, as shown in figure 11. This could cause the drill bit to be thrown from the drill, resulting in possible serious personal injury or damage to the chuck. [] Rotate the chuck clockwise to tighten the chuck jaws securely on the bit. NOTE: Rotate the chuck body in the direction of the arrow marked LOOK to tighten the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws DRILLBiT LOCK (TIGHTEN) CHUCK BODY RIGHT Fig. 10 Fig. 11 REMOVING BITS See Figure 10. [] Lock the switch trigger by placing the direction of rotation selector in the center position. [] Rotate the chuck sleeve clockwise to open the chuck jaws. NOTE: Rotate the chuck body in the direction of the arrow marked UNLOCK to loosen the chuck jaws. Do not use a wrench to tighten or loosen the chuck jaws. [] Remove the drill bit. 14

  • 1
  • 2
  • 3
  • 4
  • 5
  • 6
  • 7
  • 8
  • 9
  • 10
  • 11
  • 12
  • 13
  • 14
  • 15
  • 16
  • 17
  • 18
  • 19
  • 20
INSTALLINGBITS
See Figures
10-
11.
[]
Lock the switch
trigger
by placing the direction
of
rotation
selector
in the center position.
[]
Open or close the chuck jaws to a point where the
opening
is slightly
larger than the bit size you intend to
use. Also, raise the front of the drill slightly to keep the
bit from falling out of the chuck jaws.
[]
Insert the drill bit.
[]
Tighten
the chuck jaws on the drill bit.
UNLOCK
CHUCK
(RELEASE)
CHUCK
JAWS
COLLAR
_
WARNING:
Make sure to insert the drill bit straight
into the chuck jaws.
Do not insert the drill bit into the
chuck jaws at an angle then tighten,
as shown
in
figure 11. This could cause the drill bit to be thrown
from the drill, resulting
in possible serious
personal
injury or damage to the chuck.
[]
Rotate the chuck clockwise
to tighten the chuck jaws
securely
on the bit.
NOTE:
Rotate the chuck body in the direction
of the
arrow
marked LOOK to tighten
the chuck jaws.
Do not
use a wrench to tighten
or loosen the chuck jaws
DRILL
BiT
LOCK
(TIGHTEN)
RIGHT
CHUCK
BODY
Fig. 10
Fig. 11
REMOVING
BITS
See Figure
10.
[]
Lock the switch trigger
by placing the direction
of
rotation selector
in the center position.
[]
Rotate the chuck sleeve clockwise
to open the chuck
jaws.
NOTE: Rotate the chuck body in the direction
of the
arrow marked UNLOCK
to loosen the chuck jaws.
Do
not use a wrench to tighten
or loosen the chuck jaws.
[]
Remove the drill bit.
14