Craftsman 16225 Owners Manual - Page 10

TROUBLE SHOOTING GUIDE PROBLEM =, __J 1, Doesn't draw chemioalldeter. gent like it should ,,,,,, 2. Sputters when spraying chemical/ detergent L, ,,! LI= CAUSE ,_ . Chemical control knob not open far enough or too far open ,, Chemical/detergent not thinned enough . Chemicalldetergent not proper type for suction use. q Water control knob "ON" ii ii • • Chemical control knob open too far CORRECTION , ,,_,, • Open knob gradually until you achieve desired flow rate (2_ turns maximum) • Add water to thin the solution • Use Sears speoial oleanerldegreaser • Turn water control knob "OFF" Only air and chemical Control knobs should be "ON" Ju_,uu • Close knob until sputter stops 1 3. Not enough spray force LLI Water and/or air pressure too low = Water and air control knobs not fully open * Surface heavily soiled J,, _ L J,,, _J,,,J,L * Use Maximum water and air pres- sure available (not to exceed 175 psig) . Open both knobs fully • Scrub surface with rag or sponge to loosen dirt then rinse with air and water control knobs "ON" , ,,,_ LJ,L 4. Chemical/deter- gent doesn't combine with water pressure inside of power washer ,,1, ,, i J, • Power Washer is not designed to do this • To Wash or spray chemically usa chemical and air control knobs ON only. To Rfnse, use water and air control knobs ON only. 10