Craftsman 17541 Operation Manual - Page 14

Rating ,,, , No-load Speed , i ,i Peak HP i,u,,, Input Collets/Nuts , J,t,i and Cutter Bi't 's'hank Diameters p, Fixed Base Diameter ,, ,, ,,, ,, ,,,,,.,., Sub Base Opening (Diameter Sub Base Thickness , ,,ll ,, ,,,,,,,, for cutter bit use) ..... ,,,,,,,, . ,, , ,,, Fixed Base Depth of Cut 9°5 Amps 25,000 RPM' 13/4 ,,,,u,,i 120-volts, 60Hz AC 1/4-in.. 1/2-in.. 6qnches 1 V4-inches , , II""'"lll'" ' ' '' '' ' ,, ,,,, 0.23-inches (6ram) ,,,, ,. ,,,,, 13/4-inches (45mm) NOTE: This tool is shipped completely assembled. To install or remove bits or add accessories such as sawdust ejection hoods for hook-up to vacs, see i the following instructio,,,,,,n,,,,,s SELECTING THE CUTTER BIT This router comes with 1/4-ino and 1/2-in_ collets/nuts that accept 1/4 and 1/2-inch diameter shanked cutter bits, z_ WARNING: Do not use router cutter bits that have a cutter bit diameter larger than 11/4-inches as they will not fit through the sub-base opening, and will cause damage to the sub-base, the motor, and could cause serious personal injury to the operator. i,, ,,, ,,, NOTE: The sub-base installed on this router has an opening of 11h-inches. To use cutting bits with a larger diameter, use a sub-base with a larger opening, sold separately at Sears stores or other Craftsman outlets. Z_ WARNING: ALWAYS turn motor off and unplug router before making any "7 adjustments or installing accessories. Failure to unplug the router could result in accidental starting which can cause serious personal injury. J 14