Craftsman 21828 Operation Manual - Page 37
binds or burns work.
View all Craftsman 21828 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 37 highlights
PROBLEM Excess vibration. CAUSE SOLUTION 1 Blade is out of balance. Replace blade. Blade is damaged. Replace blade. Saw is not mounted securely. Work surface is uneven. Tighten all hardware. Reposition on flat surface. Blade is warped. Replace blade. Rip fence does not move smoothly. Rip fence not mounted correctly. Rails are dirty or sticky. Clamp screw is out of adjustment. Remount the rip fence. Clean and wax rails. Adjust clamp screw. Rip fence does not lock at rear. Clamp screw is out of adjustment. Adjust clamp screw. Cutting binds or burns work. Blade is dull. Blade is heeling. Work is fed too fast. Rip fence is misaligned. Spreader is out of alignment. Wood is warped. Wood edges away from rip fence when ripping. Rip fence is misaligned. Replace or sharpen blade. See "Heeling (paralleling) the blade to the miter gauge groove" in the Operation section. Slow the feed rate. Align the rip fence. See "To check and align the spreader/riving knife and saw blade" in theAssemblysection. Replace the wood. Always cut with convex side to table surface. Check and adjust the rip fence. 37