Craftsman 372LM User Guide - Page 2
CGI manufactured remote's code Remote Control X
UPC - 753182407586
View all Craftsman 372LM manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
When Several Remotes operate one device: To match the 372LM and 372LMC to another 315MHz CGI manufactured remote's code (Remote Control X): 1. Begin by having both the 372LM and 372LMC and Remote Control X available. 2. Press and hold both buttons on the 372LM and 372LMC until the yellow indicator light, visible on the bottom through a small hole, begins to blink. It will blink for 30 seconds; during this time it is in the learn or training mode, and the buttons can be released. 3. While it is in learn mode, hold Remote Control X, another CGI fixed or billion-code transmitter, back to back with FCC labels touching as illustrated. 4. Press and hold the Remote Control X push button as you slowly slide the remotes across each other until the 372LM and 372LMC indicator light blinks very rapidly, indicating it has learned the code. (If Remote Control X is also a 372LM and 372LMC, you must press and hold its right push button.) Yellow Indicator Light FCC Label 5. The right button is now sending the same identical Yellow Indicator coded signal as Remote Light Control X. This code will Remote Control X remain inside the 372LM and 372LMC until replaced with another new code by repeating steps 1-4 above, or by resetting to Security✚®. Resetting the right push button back to Security✚® as follows. Push and hold both buttons while observing the small yellow indicator light. Hold both buttons for ten seconds until the yellow indicator light stops blinking. The remote has defaulted to one of six randomly preprogrammed Security✚® settings. The Remote Control Batteries WARNING To prevent possible SERIOUS INJURY or DEATH: CAUTION • NEVER allow small children near batteries. • If battery is swallowed, immediately notify doctor. The lithium batteries should produce power for up to 5 years. To replace, pry open case with visor clip or screwdriver, as shown. Insert batteries positive side up (+). Dispose of old batteries properly. Replacement Parts 3V2032 Lithium battery (2 required 10A20 Visor clip 29B137 FOR SERVICE DIAL OUR TOLL FREE NUMBER: US: 1-800-528-2817 CANADA: 1-800-654-4736 114A3093C © 2006, The Chamberlain Group, Inc. All Rights Reserved