Craftsman 95355 User Guide - Page 2
EntryEase, Reference, Enroll, Additional, Users, Enroll, Initial
UPC - 012381535552
View all Craftsman 95355 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 2 highlights
EntryEase Reference Cover _ Resend button: When pressed the door will stop if X moving up or reverse if \ rnovingdown• Send LED (yellow): Lit\ after a passed fingerprint \ sianaddil.td_Cnates_at ethe and can be used to stop _ or reverse door travel. --_ Pass LED (green): Lit when _ a scanned fingerprint ki III I !"," 'ii .... 2//I I _ 'Till / I *,' // I / I t, i i I/ _L_ _ / I 1/ _l,,d I _'oy _1 i q *_'_ Enroll button: When pressed the unit will go into Enroll mode. Enroll LED (yellow): Lit when the unit is in Enroll mode• Fail LED (red): Lit when a scanned fingerprint does not match a stored print• matches a stored print. __._ Ready LED (green): Lit when unit is ready to scan fingerprint. Sensor Strip Retry LED (yellow): Lit when another swipe is required• Extra directions are located on the inside of cover• !:.@::_io£:-i_}.iTo _o_1. Step 3 Enroll Additional User(s) NOTE: The device can store up to four fingerprints at a time. An enrolled user must swipe finger first to enroll new user. 1. Open cover and wait until Ready LED is lit. 2. Press and hold Enroll button until Enroll LED starts to flash. 3. While the Enroll LED is flashing an enrolled user must slowly and firmly swipe finger. 4. The Enroll LED and Ready LED will light when ready for new user to swipe finger. i g_f_:.:.4 Step 2 Enroll Initial User NOTE: The unit requires 3 passed swipes to enroll a user. 1. Open cover to turn unit on. Wait until Enroll LED and Ready LED are lit (not flashing). 5. New user should swipe finger slowly and firmly down the sensor strip until three passed swipes are made. 6. The Enroll LED and Pass LED will flash when new user is enrolled. Unit will return to Ready mode. 2. Swipe finger slowly and firmly down the sensor strip until three passed swipes are made. NOTE: The Pass LED will light for a passed swipe. The Retry LED will light if another swipe is needed. Swipe slowly and with more pressure if this occurs. 3. After the third passed swipe, the Enroll and Pass LED will flash. Enrollment is complete. NOTE: If cover is already open, press either the Resend or the Enroll button to turn un# on. The Pass LED will light for a passed swipe. The Retry LED will light if another swipe is needed. NOTE: If cover is already open, press either the Resend or the Enroll button to turn unit on. If the Ready LED is lit refer to Factory Reset in the Erase/Reset section.